KRX Coil on Plug Conversion Kit Install Guide


DO NOT start your vehicle until the dwell table has been updated in your ECU.

Note – The vehicle used for the images has been heavily modified so the image may differ from what you see on your UTV.

Kit Contents

Item # Description Qty
1 Coil Assemblies 2
2 Wire Harness 1
3 Valve Cover Bolts 4
4 Mounting Plate w/ Grommets Installed 1
5 Aluminum Sleeves 4
6 M6 x 20mm Bolts 4
7 M6 x 55mm Bolts 2
8 M6 External Tooth Washers 2
9 M6 Nylon Locking Nuts 2
10 Zip Ties 3

Vehicle Fitment

  • This Kit fits all KRX 1000 Models.

Instructions

    1. Gain access to the top of the engine by removing the cargo bed and the air cleaner pre filter housing.
    2. Remove the OEM ignition system by first removing the spark plug wires and ignition coils.
    3. Remove and replace the factory valve cover bolts with the supplied bolts. Reuse the rubber washer under the head of the factory bolts. Torque to 89 in*lbs.
    4. Outside of the car, install the Bosch coil onto the bracket. The serrated tooth washer will go between the head of the bolt and the plate. Make sure the two coils are in line with each other and that they run parallel to the plate.
    5. Insert the spark plug boots into the spark plug bore and press down the whole assembly until the mount grommets are resting on the valve cover bolts. The electrical connectors will be facing the front of the vehicle.
    6. Connect the wire harness to the coils. Use the following as a guide:
      • Connector with the orange and green wires will connect to the driver’s side coil (Coil 1).
      • Connector with the red and black wires will connect to the passenger’s side coil (Coil 2).
      Coil Connector Guide

      Figure 1: Coil Connector Guide

    7. Route the wire harness straight back and run it along the firewall towards the OEM ignition system wires.
    8. Slide back the white cover of the male spade connectors and plug them into the OEM female spade connectors using the following connection guide:
      • OEM Brown (Coil 1) to Orange
      • OEM Black to Green
      • OEM Brown (Coil 2) to Red
      • OEM Black/Red to Black
      Spade Connector Guide

      Figure 2: Spade Connector Guide

    9. Insert the provided sleeves into the grommets on the mount.
    10. Bolt the mounting into place using the provided M6 hardware, making sure to secure the wire harness ground under the head of the top right bolt.
    11. Secure wires using the provided zip ties.
    12. Reinstall all panels that were removed in earlier steps.
    13. Follow the video below to update your dwell table using the values file found here.
      DO NOT START YOUR VEHICLE BEFORE COMPLETING THIS STEP.